The latest update to VAUX-COM is available from the update section.
This new version contains a major update to the control module list and initial coverage for new models such as the Corsa D.
Update includes:
Control unit list updated to 2007.
Added support for the following control units (fault codes, measuring blocks, output tests):
Corsa-B, EPS
Vectra-B, Alarm
Vectra-B, CDL
Omega-B, Engine Y25DT
Astra-G, Zafira Engine Y 22 DTR, PSG16
Astra-G, Engine Z14XEP
Astra-G, Zafira, Engine Z16YNG
Astra-G, Engine Z14XEP
Astra-G, Zafira, Engine Z16XEP
Zafira, Engine Z16XE
Zafira, Engine Z 20 LET
Astra-G, Engine Z14XEP
Frontera-B, Engine X22DTH
Sintra, Engine X22DTH
Speedster, Engine Z20LET
Speedster, Engine Z22SE
Meriva, Engine Z14XEP
Meriva, Engine Z16XE
Meriva, Engine Y17DT
Meriva, Engine Z17DTH
Meriva, Engine Z18XE
Meriva, ABS8
Corsa-C, Engine Z14XEP
Corsa-C, ABS8
Agila, Engine Z10XEP
Agila Engine Z12XEP
Tigra-B, Engine Z14XEP
Tigra-B, Engine Z18XE
Tigra-B, ABS8
Omega-B, Engine Y 26 SE
Omega-B, Engine Y 32 SE
Astra-G, Engine Z 17 DTL
The Corsa-D entries have been added, but currently only the fault code read, and clear function is working. There is no measuring blocks, output tests, or fault code text available. These will be added later.
Service Interval Reset on Vectra-C through diagnostic procedure is
added.
The immobiliser entry was added to the list, for
Vectra-C/Signum, Astra-H, Zafira-B.
(On these
vehicles, the immobiliser function is implemented by the CIM module).
Several changes were made in the GUI. Now you can use the keyboard, to navigate through the program (Enter, PageUp, PageDown keys can be used.)
From this version, VAUX-COM will notify you, if the selected ECU is not fully programmed, and requires additional SPS programming, with the TECH2.
Printing function now prints the name of the workshop on fault code lists etc. This was in response to a customer suggestion, and as always if you have anything you would like to see added or changed with any of our tools, please get in touch
NOTE: Since this update contains a lot of changes we are releasing it as an intermediate development version so it will not over write your current software. It will be released as a full version in the next couple of weeks. If you do use this version, please do not delete the current version from your PC until the next full update